instagram → See us on Instagram

Sometimes we need to cut around metal door frames

Sometimes we need to cut around metal door frames when they’re not installed properly. This is how it’s done 👍

Sometimes we need to cut out small rectangles and

Sometimes we need to cut out small rectangles and it’s too difficult to mount our wall saw. So we try to make rectangles out of circles, does that work? Thus is for a vent and they put a metal flange around covering the edges.

This wall is uneven, goes up and down, over 200ft

This wall is uneven, goes up and down, over 200ft around the property, we gotta cut it all flat!!

We cut a hole out of a roof slab, had to stop the

We cut a hole out of a roof slab, had to stop the concrete from falling down somehow, I think this worked pretty good 👍

We had to cut out a wall section into pieces, we c

We had to cut out a wall section into pieces, we cored a hole in it and the crane on set was able to lift it up and out 👍

Instagram post 18040972412000043

Instagram post 18040972412000043

16” hole cored through 8” wall. Foundation ha

16” hole cored through 8” wall. Foundation had styrofoam attached so we used an old blade to mount the drill 👍

The garage opening was too short, had to cut it lo

The garage opening was too short, had to cut it lower and then cut the slab inside on a slope back 12”

Follow on Instagram

Need concrete cut? We've got you covered!

GET A FREE QUOTE